Leading 10 typical forklift accidents ， forklift procedure ought to take notice of these matters ！.

Don't take too lightly the forklift at the office. If the procedure is bad, there will certainly be major crashes in mins, and there are numerous crashes entailing forklifts.

Case 1: The forklift freight obstructed the motorist's view, and the person in front can not be discovered, causing a moving mishap.
Situation 2: In order to keep the balance of the forklift when raising hefty items, the workers used their body weight as the weight, which almost triggered casualties.
Instance 3: The size of the forklift cargo exceeds the allowed width of the course and holds on the roadside rack, which nearly creates an mishap.
Instance 4: Forklift is speeding up and rolls over during a turn.
Situation 5: The forklift vehicle driver did not discover the pedestrian, and the pedestrian did not discover the forklift.
Case 6: The forklift lifts the workers illegally, the forklift driver does not put on the safety belt, the forklift lifter falls and the vehicle driver is squashed when the forklift rolls over.
Situation 7: The forklift chauffeur did not wear a seat belt and dropped from the lorry when it surrendered and was squashed.
Forklift procedure must take note of these issues ：.

Begin.
1. Before beginning, observe the environments, and after confirming that there are no barriers that hinder the security of driving, honk the horn first and after that begin.
2. For automobiles with hydraulic (air pressure) brakes, the brake hydraulic pressure ( atmospheric pressure) scale have to be safe before beginning.
3. When the forklift starts with a tons, the motorist must first validate that the load is secure and trusted.
4. The begin needs to be slow and steady.

Driving.
1. When driving, the height between the bottom end of the fork and the ground need to be kept at 300mm-400mm, and the mast needs to be slanted backwards. .
2. Do not lift the fork too expensive when driving. When entering and leaving the job site or while driving, beware that there will certainly be no barriers in the sky. When the load is traveling, the fork must not be increased too high, which will certainly influence the stability of the forklift. .
3. After discharging, the fork should be reduced to the regular driving placement prior to driving. .
4. When turning, if there are pedestrians or automobiles nearby, the driving signal ought to be released initially. High-speed doglegs are forbidden. High-speed sharp turns will trigger the vehicle to lose lateral security and topple. .
5. When the forklift is downhill, it is strictly restricted to turn off the fire and slide, and it is forbidden to brake suddenly while driving with loads unless there are unique conditions.
6. When the forklift is running, it has to comply with the web traffic rules in the factory and should keep a certain security range from the automobile ahead. .
7. When the forklift is running, the tons should be in the lowest position that does not hinder the driving, and the gantry must be properly tilted back. The lots will not be increased except when piling or filling. .
8. The elevation of the lots have to not obstruct the vehicle driver's sight. In unique conditions, when the product affects the forward vision, drive at a reduced rate when turning around.
9. It is prohibited to turn on the ramp, nor to drive throughout the ramp. .
10. The secure driving speed of the forklift in the factory location is 5 km/h, and it has to drive securely at a low speed when getting in the manufacturing workshop location. .
11. When the forklift is lifted, lifted or driven, it is restricted for employees to depend on the fork to hold items and play a balancing duty. .
12. If troubles are located, they will certainly be fixed and reported in a timely fashion, and they will never run with health problems or hide them.

filling and dumping.
1. When fork-loading items, the distance in between both forks ought to be changed as required to make the lots of the two forks well balanced and not manipulated, and one side of the thing ought to protest the shelf. .
2. It is forbidden to work with Electric Forklift Truck for Warehouse a single fork or use a fork top or draw. In unique circumstances, security indication have to be established to remind surrounding pedestrians. .
3. In the process of loading and unloading items, the forklift must be braked with the brake. .
4. The rate of the automobile should be slow-moving and constant. Be careful not to roll the wheels on the dunnage, so as not to stretch the rolled items and hurt individuals. .
5. When making use of a fork to fork the goods, the fork should be as deep as possible under the tons, and it must be kept in mind that the fork tip should not touch various other items or items. The lots must be supported with very little back tilt of the gantry to ensure that the load does not slide backwards. The mast can be slanted ahead slightly when the lots is decreased to allow for very easy positioning of the tons and extraction of the forks. .
6. It is forbidden to fork items at high speed and ram difficult objects with the fork head. .
7. When the forklift is working, it Electric Forklift Truck for Warehouse is forbidden for people to loaf the fork, so regarding prevent the collapse of the goods and hurt people. .
8. Overwhelming is banned, and it is banned to utilize forks to raise workers to engage in high-altitude procedures to avoid high-altitude dropping crashes. .
9. It is not enabled to utilize the brake inertia to slip, place, round or roll things. .
10. It is not allowed to use forks to choose, turn pallet dump.

Leaving .
1. It is prohibited to leave the forklift when the products on the fork impend. Before leaving the forklift, you must dump the goods or reduced the fork framework.
2. Draw the hand brake handle to dead or dispirit the emergency brake switch.
3. The engine is switched off and the power is cut off. (Except for unique situations, such as the vehicle driver does not leave the automobile's view and does not surpass 1 min).
4. Get rid of the secret. .

Forklift Operation Precautions.
1. Prior to and after the forklift operation, the look must be examined, and gas, lubricating oil and air conditioning water need to be added.
2. Inspect the safety performance of starting, running and braking.
3. Inspect whether the lights and horn signals are total and effective.
4. Throughout the procedure of the forklift, examine whether the stress and temperature are typical.
5. After the forklift is running, the outside leakage must additionally be inspected and the seals need to be replaced in time.

Forklift Safety Operation Specifications.
1. You need to inspect prior to leaving the vehicle;.
2. When you run into a person in front of you during driving, you need to send out a signal at a distance of 5 m;.
3. The driving speed in the manufacturing facility does not go beyond 5 km/h;.
4. When driving, the low point of the cargo need to be 0.3 m ~ 0.4 m above the ground;.
5. The turning must not be too sharp to stop the propensity of " totally free switching";.
6. Adding and down the incline ought to be slow and consistent, and no activating the slope is permitted.
7. Do not drive across the gradient. When the slope is higher than 10%, the lorry must be driven backwards when declining;.
8. When the forklift personnel lug the goods and move forward, if they run into big or hefty goods and most likely to the chauffeur's view, they should take the turning around exercise
.
The "Eight Prohibitions" ought to be adhered to in the operation.
1. Solitary fork procedure is not enabled.
2. It is not permitted to lift the goods for far away driving.
3. It is not permitted to pick up the goods by handing over the pallet with the fork.
4. It is not permitted to directly shovel chemicals, flammables and various other unsafe chemicals with forks.
5. It is not allowed to utilize inertia pressure to pick up the goods.
6. It is not enabled to utilize stopping force to exile round or easy-to-roll items.
7. It is not permitted to bring people to deal with the pallet or fork, and it is purely restricted to stand under the fork after the fork is raised.
8. Do not drive laterally on slopes
.
Parking is not permitted under the following problems.
1. Contours, slim roadways, railway crossings;.
2. Sections with a longitudinal slope higher than 5%.
3. When there is an barrier on one side of the roadway, the contrary side of the area with the same length as the obstacle must be within 20 meters at each end.

Web：https://www.onenforklifts.com/
Email：[email protected]
Phone：+86 13827083844